Altec Analog Socket Modem AL2094S Uživatelský manuál stáhnout pdf (Strana 29)

AL2094S Designers Guide

Doc. No. DG_2094E Altec Electronic AG Seite 29 / 30

Clearance and creepage between primary (mains) and secondary circuits according EN

60950-1:2001, clause 2.10.3.2 table 2H and clause 2.10.4 table 2L.

Minimum distances between primary and secondary circuits (f.g. for mains voltage 230 V

Clearance = 4 mm

Creepage = 5 mm

Failure to maintain these minimum distances would invalidate the approval.

NOTE: For a host or other expansion cards fitted in the host using or generating voltages

greater than 300 V (rms or dc), advice from a competent telecommunications safety

engineer must be obtained.

If these clearance and creepage distances cannot be provided inside the host due to space

limitations, a dielectric material may be used as a physical insulation barrier. The dielectric

material used in this insulation must have a thickness of at least 0.4mm

After installation (or implementation) of the Socket Modem inside a host system, it is

recommended that a competent telecommunications safety engineer inspects the

complete system to ensure that safety compliance is maintained.

(TNV = Telecommunications Network Voltages)

1 2 ... 24 25 26 27 28 29 30

Žádné komentáře

Altec Analog Socket Modem AL2094S Uživatelský manuál Strana 29